Boat Shipping Calculator

← Boat Shipping Glossary

Oversize Load

A shipment that exceeds a state's standard legal width, height, or length limits — for boats, this is triggered once beam exceeds 8.5 ft. Oversize loads require permits, and sometimes escort vehicles, in every state they cross.

What makes a boat an oversize load

A boat becomes an oversize load when it is wider than 8 ft 6 in, or when the boat on its trailer is taller than the legal clearance, about 13 ft 6 in in most states. Length rarely matters for trailerable boats, but very long yachts can also need permits.

Most center consoles, bass boats, bowriders and jet skis are within legal width. Many cruisers, catamarans, sailboats over about 30 ft and almost all motor yachts are not.

What an oversize load adds to the cost

Every state on the route charges a permit fee, commonly $50 to $250. From about 12 ft of beam, most states require a pilot car, at roughly $1.50 per mile; past about 14.5 ft, two escorts are common. Very wide or tall loads may also need a route survey.

Oversize loads can't always travel at night, on weekends or on holidays, so trips take longer. Plan for a slower schedule as well as the higher price.

Ways to avoid it

Take off what you can: arches, towers, antennas, outriggers and the mast. That often brings height under the limit. Beam can't change, so for very wide boats, compare overland trucking with moving the boat by water, which avoids highway permits altogether.

Check your boat's numbers before you collect quotes, so you can compare carriers on the same basis.

Go further

Estimate your boat shipping cost with the free calculator.

More dimensions & regulations terms

Beam

The width of a boat at its widest point. Critical for determining if a transport requires oversize load permits.

Draft

How deep a boat's hull sits below the waterline. Relevant for in-water and RoRo transport, since it determines which marinas, ramps, and loading berths a vessel can use.

Freeboard

The height of a boat's hull above the waterline. Along with air draft, it factors into clearance calculations for bridges and low-hanging obstacles during in-water moves.

Air Draft

The total height of a boat from the waterline to its highest fixed point, including towers, antennas, and outriggers. Determines whether a route's bridges and power lines can be cleared without dismantling.

Height Pole

A pole mounted on a lead escort vehicle to physically check overhead clearance ahead of an oversize load, used when a loaded trailer approaches 13.5–14 ft.

Wide-Load Permit

A state-issued permit authorizing a vehicle and its cargo to travel at a width beyond the standard legal limit. Boat haulers typically need one per state once beam passes 8.5 ft, at roughly $50–$250 apiece.

Axle Weight

The portion of total load weight resting on each axle of the trailer. States cap axle weight independently of gross weight, which can force a heavier boat onto a trailer with more axles even if the total weight seems reasonable.

Gross Vehicle Weight (GVW)

The combined weight of the tow vehicle, trailer, and boat. Exceeding federal or state GVW thresholds can require additional permits and route restrictions beyond those triggered by width alone.

DOT Number

A unique identifier issued by the Federal Motor Carrier Safety Administration (FMCSA) to any commercial carrier operating across state lines. Always confirm a hauler's DOT number before booking.

FMCSA

The Federal Motor Carrier Safety Administration, the agency that regulates and licenses commercial trucking companies in the US, including boat haulers operating interstate.

MC Number

A Motor Carrier number issued by the FMCSA to carriers authorized to transport regulated freight for hire across state lines. Distinct from a DOT number, which every commercial vehicle needs.

Go deeper