Boat Shipping Calculator

← Boat Shipping Glossary

Air Draft

The total height of a boat from the waterline to its highest fixed point, including towers, antennas, and outriggers. Determines whether a route's bridges and power lines can be cleared without dismantling.

Air draft explained

Air draft is the vertical distance from the waterline to the highest fixed point on a boat: the top of the mast, radar arch, tuna tower, antennas or outriggers. Draft is the opposite measurement, from the waterline down to the bottom of the keel.

On the water, air draft decides which bridges you can pass under. Charts list bridge clearances, and tidal range changes the real clearance through the day.

Air draft vs transport height

When a boat goes on a trailer, what matters is its total height on the trailer: the boat's height from the bottom of the keel to its highest point, plus the trailer deck. That is not the same as air draft, because the part of the hull that sat below the water now sits above the road too.

Most states allow about 13 ft 6 in of total height before a load needs an oversize permit. Lowering a radar arch, removing antennas, or unstepping a sailboat's mast is often what keeps a boat under that limit.

How to measure it

Check the manufacturer's spec sheet first, then measure the boat as it will travel. Take the keel-to-top height with everything that can't be removed in place, and ask the carrier for their trailer's deck height. Add the two to get the loaded height.

Measure twice and tell the carrier the real number. A boat that turns out taller at pickup can mean new permits, a different route, or a pickup that doesn't happen.

Go further

Estimate your boat shipping cost with the free calculator.

More dimensions & regulations terms

Beam

The width of a boat at its widest point. Critical for determining if a transport requires oversize load permits.

Oversize Load

A shipment that exceeds a state's standard legal width, height, or length limits — for boats, this is triggered once beam exceeds 8.5 ft. Oversize loads require permits, and sometimes escort vehicles, in every state they cross.

Draft

How deep a boat's hull sits below the waterline. Relevant for in-water and RoRo transport, since it determines which marinas, ramps, and loading berths a vessel can use.

Freeboard

The height of a boat's hull above the waterline. Along with air draft, it factors into clearance calculations for bridges and low-hanging obstacles during in-water moves.

Height Pole

A pole mounted on a lead escort vehicle to physically check overhead clearance ahead of an oversize load, used when a loaded trailer approaches 13.5–14 ft.

Wide-Load Permit

A state-issued permit authorizing a vehicle and its cargo to travel at a width beyond the standard legal limit. Boat haulers typically need one per state once beam passes 8.5 ft, at roughly $50–$250 apiece.

Axle Weight

The portion of total load weight resting on each axle of the trailer. States cap axle weight independently of gross weight, which can force a heavier boat onto a trailer with more axles even if the total weight seems reasonable.

Gross Vehicle Weight (GVW)

The combined weight of the tow vehicle, trailer, and boat. Exceeding federal or state GVW thresholds can require additional permits and route restrictions beyond those triggered by width alone.

DOT Number

A unique identifier issued by the Federal Motor Carrier Safety Administration (FMCSA) to any commercial carrier operating across state lines. Always confirm a hauler's DOT number before booking.

FMCSA

The Federal Motor Carrier Safety Administration, the agency that regulates and licenses commercial trucking companies in the US, including boat haulers operating interstate.

MC Number

A Motor Carrier number issued by the FMCSA to carriers authorized to transport regulated freight for hire across state lines. Distinct from a DOT number, which every commercial vehicle needs.

Go deeper